Knowledgebase: outmail
How do I change the port on MS Exchange 2010 SMTP Send Connector?

Problem:

How do I change the port on MS Exchange 2010 SMTP Send Connector?

Solution:

By default the SMTP Send Connector is set to use port 25 with a Smart Host. However if you need to change the port from port 25 to port 587 then follow the below instructions.

Launch the Exchange Management Shell (EMS).

Use the following command in the Exchange Management Shell to get the current Connector information.

Get-SendConnector

To change the port to 587 use the following command

Set-SendConnector "Your SMTP Send Connector" -Port 587

(235 vote(s))
Helpful
Not helpful





Disclaimer
The Origin of this information may be internal or external to Prolateral Consulting Ltd. Prolateral makes all reasonable efforts to verify this information. However, the information provided in this document is for your information only. Prolateral makes no explicit or implied claims to the validity of this information. Any trademarks referenced in this document are the property of their respective owners.